Banner_Mortar
You are here:Home/Mortar/Specific Purpose/TPI M220 for Infill Wall

TPI M220 for Infill Wall

Precast concrete is used for mixing foam pellets. (EPS) to use for lightweight walls. Provide insulation properties Heat and sound protection

SCOPE OF USE

Mix with EPS foam and water at a given ratio. For pouring into the space of the wall installed Fiber Cement Plate prepared. To make a light wall Can be used with a mortar sprayer.

RAW MATERIAL

  • TPI Portland Type 1 Cement according to ASTM C-150 and TIS 15-2555
  • Chemical additives improve water quality. Extra high adhesion strength.
  • Fine limestone crushed

HOW TO PREPARE THE SKIN AND USE.

  • Wall preparation: Install a lightweight fibreboard wall panel, installed on both sides of the wall, to the center of the gap. With a hole in the top to use in the finished foamed foam mixture into. Thickness and methods are in accordance with Fiber Cement manufacturer's recommendations.
  • Mix 1 piece of lightweight wall mortar (50 kg) with EPS foam foam with a diameter of about 1-5 mm, 36 liters and 17 liters of clean water.
  • Use a mortar machine Finishing the foam mixture into the space of the prepared fiber cement wall.
  • Clean the interior according to the method recommended by the Fiber Cement manufacturer.

QUALITY OF USING

  • 700 kg of lime (14 bags per 50 kg) of EPS foam with a diameter of about 1-5 mm 500 liters and 170 liters of clean water when mixed with foam. It will have a volume of about 1 cubic meter.

RFQ

Form by ChronoForms - ChronoEngine.com